Remove the gasket and its remnants.
Capping off toilet waste pipe.
Slice off a bit of the top of the pipe embedded in the floor.
End cap for main drain out let.
Capping them requires the use of a pvc cleaner and a pvc glue to hold the new cap securely.
Measure from the end of each pipe and make a depth marking as directed by the push on fitting manufacturer.
Many of today s drainpipes are pvc.
Get a cleanout or expandable test plug that fits.
Sink disconnect pipes place end caps to water pipes disconnect out let pipe cut of to desired place cap of pipe.
Cap the pipes.
Water pipe 1pm caps.
Sink 50mm 2 inch cap.
This will involve removing a portion of the surrounding concrete removing the floor flange which may have to be cut out and then the capping the pipe.
You could also probably chip it out with a knife sharp chisel.
If the top of the plug still sticks out above the floor you can get an internal pvc pipe cutter which is like a rotary dremel circular saw blade on a drill shaft.
Turn off the feed valve drain the water from the tank unhook the feed line and remove the anchoring bolts with a wrench.
The mark will tell you when the fitting is pushed on all the way which is essential for a proper seal.
To permanently close off the pipe in a concrete slab the floor flange should be removed and the pipe capped below the floor surface.
Pull the toilet up and out of the way.
Push the pipe cap onto the pipe until its edge reaches the depth mark.